Jackshaft diameter question

Status
Not open for further replies.

Slackjumper

Angle Grinder Surgeon
Messages
57
Reaction score
0
Location
Sandpoint Idaho
With a 40 series TC, what Engine Torque is the 5/8" jackshaft good to? I've got a GX390 build starting and am considering reusing the old 5/8 bore driven pulley and JS. Will this last with hard riding?
 

landuse

Moderator
Staff member
Messages
18,803
Reaction score
611
Location
Pietermaritzburg, South Africa
With a 40 series TC, what Engine Torque is the 5/8" jackshaft good to? I've got a GX390 build starting and am considering reusing the old 5/8 bore driven pulley and JS. Will this last with hard riding?

It sounds a bit thin to me, but depending on the bearing placement on the jackshaft it could be OK
 

Slackjumper

Angle Grinder Surgeon
Messages
57
Reaction score
0
Location
Sandpoint Idaho
Setup

It's the stock manco dingo 388 shaft and plate. The sprocket is opposite side from the pulley. Bearings are close to the pulley and sprocket.
 

Attachments

  • image.jpg
    image.jpg
    21.7 KB · Views: 47

Whitetrashrocker

Inmate #952016
Messages
5,235
Reaction score
4,731
Location
Southern New Mexico
The 5/8 shaft will be just fine.

Now the stock Manco JS bracket will fail. I've done some minor engine mods and ride it hard. The bearing retaining sleeve will try to separate from the base plate.

You might be able to see the welds breaking in these pics.
 

Attachments

  • IMG_20170227_151719731.jpg
    IMG_20170227_151719731.jpg
    205 KB · Views: 7
  • IMG_20170227_151736914.jpg
    IMG_20170227_151736914.jpg
    198.6 KB · Views: 6
  • IMG_20170227_151742551.jpg
    IMG_20170227_151742551.jpg
    152.1 KB · Views: 10

Slackjumper

Angle Grinder Surgeon
Messages
57
Reaction score
0
Location
Sandpoint Idaho
The 5/8 shaft will be just fine.

Now the stock Manco JS bracket will fail. I've done some minor engine mods and ride it hard. The bearing retaining sleeve will try to separate from the base plate.

You might be able to see the welds breaking in these pics.

Thanks! I will beef it up. I was thinking of mounting the sleeve to a 1/4" flat plate for lower center if gravity anyhow.
 

Slackjumper

Angle Grinder Surgeon
Messages
57
Reaction score
0
Location
Sandpoint Idaho
I just removed the 5/8 jackshaft from the old 40D driven pulley with much effort. The 3/16 key had somewhat embedded itself into the shaft (slightly) and the sprocket key did so much that part of the threads were beginning to shear! And that was only with the Briggs 8hp flathead. So you can see my concern here. I could go up to 3/4" JS but the keyway is still 3/16.

Folks who have put the GX390 on a 5/8 JS, did you see this happening after some years? Or is this just crap metal on the Mango stock JS. Is Azusa much better, hardened or something?

Sent from my LG-H932 using Tapatalk
 
Status
Not open for further replies.
Top