ISO: Non-Hemi predator valve keepers

Status
Not open for further replies.

Vtecmonster

New member
Messages
13
Reaction score
0
yes stock. i have not measured them but understand the non-hemi heads come with 5mm valves. Is this true?
 

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,830
Location
Chicago-town USA
Old non Hemi's were 5.5.
Hemi's are 5.5.
New Non-Hemis are 5.0mm.

I have the retainers for the stock 5.5mm valves.
I haven't seen the retainers for the 5.0mm valves, although I've been told they are much better than the stock ones for the 5.5mm. They are automotive style with split keepers.
If you have a 27mm intake on a non-hemi, it should have the 5.0mm stems. If you have a 25mm intake, it should have 5.5mm stems.

You might be SOL finding those 5.0 retainers and keepers.
Might have to install 5.5mm stemmed valves - which would need new or modified valve guides.

I found a guy on FB that might part with a take off set of 5.0 retainers and keepers if you need. I could probably initiate the parley.

---------- Post added at 03:09 PM ---------- Previous post was at 02:29 PM ----------

STUDZ Hardware / Powersports
313-563-1058


Or I've been told that Dynocams probably has them.
Call dynocams and ask.
 

Vtecmonster

New member
Messages
13
Reaction score
0
let me pop the head off and make sure i didnt lose it in there. Why are these things so easy to lose and so hard to replace?
 

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,830
Location
Chicago-town USA
let me pop the head off and make sure i didnt lose it in there. Why are these things so easy to lose and so hard to replace?

I buy extras because I loose them all the time.
Studz has them for you.
Dynocams might have them. Call them.
I sparked a FB debate about the Ducar engine. I don't know much about it.

---------- Post added at 03:30 PM ---------- Previous post was at 03:28 PM ----------

OK, so now I hear the ducar is a Hemi.
And you should call STUDZ to get what you need.
 
Status
Not open for further replies.
Top