Is this just a cheap clone?

[Kaptain Krunch]

That's because in Denmark it's not like you can run down to Harbor and pick one up for $89. Prices vary dramatically based on where you are, taxes, import laws. Overseas - a Briggs would likely cost $500+ So the $250 is relatively decent I suppose.

I guess if you compare it to his other similar options, but im sure for $250 he could find a lifan motorcycle engine. Like i said, i wouldnt pay more than $25 for one of those clones.

 

[Blazkowiez]

Your bolt pattern on the clone gx200 will have the same bolt pattern as 3-6.5hp briggs, gx120-gx200 honda, and 3-11hp tecumseh. You must keep in mind that tank designs and size of the engine does vary though the bolt pattern on these specific engines does not.

The only deviation on this bolt pattern design will be in engines designed for the sole purpose as an edger where it was bolted from underneath the engine into regular thread 3/8" drilled and tapped holes.

 

[kkmmbb]

Okay. Thanks guys for all the great answers! It helped alot!

I've been looking through this website, and it seems to have all i need, and its not that expencive. Its kindda cheap

Has anyone of you guys tried to buy from it before? It has a clone for 150$, clutch for 25$ and so on. And they ship internationally!!!

Its: http://www.bmikarts.com/

 

[kkmmbb]

Hasen't anyone bought something from http://www.bmikarts.com/ before?

 

[Russ2251]

Several times.

 

[Daveon]

No problems with bmi

 

[kkmmbb]

Okay that sounds good! Im planning on putting an order for about 300-350$ soon. Just wanted to make sure they are good. Thanks guys!