Is this Briggs any Good?

Status
Not open for further replies.

Kentucky Boy

Member
Messages
611
Reaction score
49
Location
Bowling Green, KY
Got my carb cleaned up and replaced the diaphragm. Put it on the tank with new gaskets. Just have to instal the flywheel and ratchet starter. Also installed new breather tube boots.

One more then calling it a day.

Flywheel has been de-rusted, painted, lapped and re-installed. Cleaned up and installed the ratchet starter. Just needs the pull starter painted and installed.
 

Attachments

  • IMG_3436.jpg
    IMG_3436.jpg
    303.4 KB · Views: 8
  • IMG_3430.jpg
    IMG_3430.jpg
    289.1 KB · Views: 15
  • IMG_3452.jpg
    IMG_3452.jpg
    198.1 KB · Views: 9
Last edited by a moderator:

Kentucky Boy

Member
Messages
611
Reaction score
49
Location
Bowling Green, KY
New pic for today. Got the flywheel torqued down and installed the ratchet starter and dust screen. New air filter is on.
 

Attachments

  • IMG_3500.jpg
    IMG_3500.jpg
    350.2 KB · Views: 6

Kentucky Boy

Member
Messages
611
Reaction score
49
Location
Bowling Green, KY
More gooder.

Cleaned the starter spring and put it all together. Time for the water decals. They came from Mini Bike Paul. Very nice quality and a good way to finish this motor off.

The decals are very nice and pretty easy to apply. I'm not sure where the rest of them go. Any ideas?
 

Attachments

  • IMG_3499.jpg
    IMG_3499.jpg
    366.9 KB · Views: 12
  • IMG_3555.jpg
    IMG_3555.jpg
    368.4 KB · Views: 9
  • IMG_3559.jpg
    IMG_3559.jpg
    401.9 KB · Views: 6
Last edited by a moderator:

Kentucky Boy

Member
Messages
611
Reaction score
49
Location
Bowling Green, KY
I put the caution fill crankcase with oil one on top of the gas tank, pictures I've found show it there. It looks like the model type code decal actually goes over the numbers on the side of the starter cover. But they will cover up the stamped numbers.

Just need to put a spark plug boot on it.

Before and after.
 

Attachments

  • IMG_3571.jpg
    IMG_3571.jpg
    242.4 KB · Views: 7
  • IMG_3583.jpg
    IMG_3583.jpg
    351.1 KB · Views: 10
  • IMG_3587.JPG
    IMG_3587.JPG
    335.8 KB · Views: 12
Last edited by a moderator:

anickode

Active member
Messages
2,296
Reaction score
77
Location
S.E. Michigan
Original decal locations

This is a 2hp, but the same original paint/decal combo. I believe locations should all be the same
 

Attachments

  • IMG_20180414_161304.jpg
    IMG_20180414_161304.jpg
    244.4 KB · Views: 8

Kentucky Boy

Member
Messages
611
Reaction score
49
Location
Bowling Green, KY
I put that decal on the other side since it would have covered up my numbers.

Put a new spark plug boot on it. It's done.
 

Attachments

  • IMG_3572.jpg
    IMG_3572.jpg
    248.6 KB · Views: 12
  • IMG_3596.jpg
    IMG_3596.jpg
    345.6 KB · Views: 20
Last edited by a moderator:
Status
Not open for further replies.
Top