Is this a good torque converter?

Status
Not open for further replies.

NotSoMasterMind

New member
Messages
112
Reaction score
1
Location
South lyon michigan
I was looking for a 40 series torque converter and found this on amazon (link below) and was wondering if it is worth the money for me to get it. It was originally $200 and is now half off at just under $100.

CNCShop Torque Converter Comet Clutch Go Kart Clutch 40 Series 0.75 Inch Driven 1Inch Driver Clutch Pulley Set Kit Comet 40D (3/4" Driven 1" Driver Clutch) https://www.amazon.com/dp/B019SL0LUK/ref=cm_sw_r_cp_api_0pyCyb07FBRGK
 

B_Bimmer

Member
Messages
200
Reaction score
1
I wouldn't put much stock in the original price when assigning value but based on the reviews it appears to be an acceptable 40 series knockoff.
 

itsid

Moderator
Staff member
Messages
11,563
Reaction score
260
Location
Ruhrpott [Germany]
minor complaints about the longevity of the chinese belts every now and then...
that's it.
and since you can replace a crappy belt with a quality one (as you can always do)
I don't see a problem at all in buying a 100 dollar series 40 kit.

'sid
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
The Chinese belts for the 40 series torque converter have the proper width and outer circumference, but are thinner than the genuine comets. You get less surface area contacted on the drive and driven, so the belt slips easier.
 

Joe-405

Enjoying New Projects
Messages
2,673
Reaction score
98
Location
U.S.A.
I would say that will work just fine. Just don't use a high rev engine or highly modded 420 with it. Mine was fine til I turned the timing up and ran it on full kill past 6000 rpms.
 
Status
Not open for further replies.
Top