Is the clutch still good?

Status
Not open for further replies.
Messages
357
Reaction score
7
Location
Dallas, TX
Recently acquired this buggy, it’s a Revo by Carter Striker and it has the GY6 150cc. I know the gentlemen I bought it from and he only used it a couple of hours. tops. Either way I took the cover off to see the state of the belt and clutch and honestly not sure what to even look for. There is no blueing anywhere and the springs on the shoes are pretty tight, I have to pull like a mule to move them even a little.

I have attached a couple of pics of the clutch, should I buy one as a spare or does this clutch have good life left in in. The buggy has been used at low speed by the PO so it may have gotten a work out.

Thanks
Dan
 

Attachments

  • DD3F5EB1-2F71-496E-A076-B4854696BB83.jpg
    DD3F5EB1-2F71-496E-A076-B4854696BB83.jpg
    212.6 KB · Views: 5
  • F7A03BE3-65F1-4BFF-AB36-89C9F98A09A6.jpg
    F7A03BE3-65F1-4BFF-AB36-89C9F98A09A6.jpg
    302.8 KB · Views: 6
  • FE6F4C6D-A19B-47C4-865F-2097D64F187B.jpg
    FE6F4C6D-A19B-47C4-865F-2097D64F187B.jpg
    320.4 KB · Views: 12

itsid

Moderator
Staff member
Messages
11,563
Reaction score
261
Location
Ruhrpott [Germany]
I'd say they're fine as well..

since they pivot off center, it's easy to spot excessive wear if the "front" is less worn than the "back"

but if you want to be perfectly ure, just find any gy6 manual (carter or not doesn't matter much) and see what wear levels are on the clutch shoes.

But again.. if that's what I'd see under my clutch bell I wouldn't even think much about it and call it good until I notice issues on the clutch engagement ;)

'sid
 
Status
Not open for further replies.
Top