Is governor removal necessary?

Status
Not open for further replies.

RockRon

New member
Messages
6
Reaction score
0
Wow! Didn't mean to cause all the ruckus, guys! I didn't get back to making the measurements but I'd bet you're on the right track with gear ratio. The used lawn tractor tires so it's got a pretty big rear tire and the 3 HP engine guess is probably right. So it looks like they'll need to find a bigger engine or smaller tires...and I get my mower back!
 

JHen

New member
Messages
225
Reaction score
2
Wow! Didn't mean to cause all the ruckus, guys! I didn't get back to making the measurements but I'd bet you're on the right track with gear ratio. The used lawn tractor tires so it's got a pretty big rear tire and the 3 HP engine guess is probably right. So it looks like they'll need to find a bigger engine or smaller tires...and I get my mower back!

Or a larger axle sprocket.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
if you have trouble turning big tires with your motor you don't need smaller tires just a lower gear ratio
True, but only to a point. Being largely underpowered, and gearing for such, leaves you moving pretty slowly. As an over-illustrated example, you could move a '77 Blazer with a chainsaw engine, but you'd have to gear it so obscenely deep that you could lie down on the ground and drag yourself by your lips faster than the truck'll move...
 

Scummie

PCWiz, GoKart NewB
Messages
1
Reaction score
0
As an over-illustrated example, you could move a '77 Blazer with a chainsaw engine, but you'd have to gear it so obscenely deep that you could lie down on the ground and drag yourself by your lips faster than the truck'll move...

Interesting example. I've been contemplating using a chainsaw engine to drive a scooter- not a puny razer scooter, but one from the late '80s/early '90s (note correct punctuation, ya flamerz ;) ). I figured that the clutch drives a chain anyway, so if I can get a big enough gear on the rear wheel (currently 12" diameter), I could actually get the clutch to engage and the thing to move, a little at least.
It turns out that the clutch doesn't actually have a gear on it, so I'll have to make one that fits somehow. I have a number of ideas, and hoping to find something that'll work at the swap meet this weekend.
Maybe I should've made this a new thread. Any suggestions welcome.
 
Status
Not open for further replies.
Top