impossible?

Status
Not open for further replies.

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
well today i took my mini bike to my high schools empty parking lot, and i ran the engine hard and fast, mu uncle who was there said it looked to be going about 40, its a 4:1 ratio, to tooth max torque clutch and a 42 tooth rear both a 41 chain, is going 40 on this impossible?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Well- looks can be deceiving. But it's possible. Let's examine this mathematically. Tell us the diameter of the rear tire, and the maximum RPM of the engine.

How many teeth are on the clutch? You said 4:1, but you also said a 42T rear- do you have a jackshaft and/or a CVT?

EDIT- fwiw, I just played with some numbers and 40 MPH is feasible at 3600RPM if you have a rear tire with a 15" overall diameter.
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
its a direct setup with a 10 tooth front and 42 tooth rear. its 36000rpm no governor removed just aftermarket air filter and header with silencer. and the rear tire diameter is actually 15" overall
 

gokart14

New member
Messages
1,115
Reaction score
1
Location
Nebraska
exactly jut put the demensions in the DIY speed caculator came out at 38 mph yep it is confirmed (muthbusters lol)
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Well- at 4.2:, 3600RPM, 15" tire, there ya go- just shy of 40. As far as backing out the throttle stop screw- you might get up to 4200 with the screw out, that's what my GX340 was turning.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
... It's feasible. Bear in mind that the speed calc does not factor in your engine's available power, vehicle weight, etc. But it doesn't hurt to try. It's does hurt to dump it at that speed- so be careful and wear a helmet and maybe some other appropriate safety gear...
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
i wear fingerless snap on tool gloves, a helmet which im getting ready for a new one, and sometimes some saftey glasses, and well the engine flys, and i think the engines maybe 25 30 pounds and i weigh 73 and i havent dumbed a minibike since i was 6
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
yea i always wear a helmet when i ride in the woods, cant go on the road at all. not a bit of pavement other than the driveway.

i have fallen once but it wasnt bad, i lost it around a turn behind my friend. i was ok thoough.
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
i still dont have that throttle setup and not a pair of gloves fit me lol, so i can feel what the hell im doing in between the throttle and choke
 
Status
Not open for further replies.
Top