tedbeerman
New member
- Messages
- 1
- Reaction score
- 0
Does anyone know what size bolt goes in the end of my crankshaft on my predator 420cc engine? I need a bolt and washer to hold on my centrifugal clutch on....
Im stumped !!
- Thread starter tedbeerman
- Start date
- Status
xXPhasemanXx
Newb
Does anyone know what size bolt goes in the end of my crankshaft on my predator 420cc engine? I need a bolt and washer to hold on my centrifugal clutch on....
We would have no idea without a picture. Even then it would be hard to tell. Why not just measure the width?
OzFab
Well-known member
Not off hand; have you consulted the user manual?
KartFab
Active member
its going to be a fine (not coarse) thread whatever it is. Bolts are cheap so if you don't know, just buy a 5/16ths and cross your fingers?
domtrain
New member
bring the motor to home depot. you can test fit all the bolts ya want, they didnt mind when i took my gx200 in.
Does anyone know what size bolt goes in the end of my crankshaft on my predator 420cc engine? I need a bolt and washer to hold on my centrifugal clutch on....
3/8″ - 24
http://www.homedepot.com/p/3-8-24-x...el-Hex-Cap-Screw-10026/100337758#.UbfwCmWCeeg
- Status