i need some advice on gearing

Status
Not open for further replies.

rootcory

New member
Messages
18
Reaction score
0
Ok so I'm building a full suspension cart and I'm a little messed up on gearing

The Kart is a carter hammerhead style two seater the engine is a 500 cc arctic cat fan cooled I decided to go with a twin jackshaft setup with a 10t to a 45 t and another 10t to a 45t sprocket on the axle thus giving me a 9 to 1 ratio? Is this to much what would u guyss reccomend?
For a ratio?
 

dpaxson

New member
Messages
346
Reaction score
0
Location
parma heights, oh
plus you have to multiply that ratio by the initial ratio of the sled cvt. unless you wanna drive up walls that's gonna be too low
 

HellSpawn

New member
Messages
476
Reaction score
2
Location
Wadena, Minnesota
6:1, but considering 2strokes wind out much further, you could go 7 or 8:1 for a really snappy low end. And still have a decent top end.
 

rootcory

New member
Messages
18
Reaction score
0
So how do I figure out the sprockets I need? I really don't want to change my axle sprocket it is a 45t now and I just got it custom made NOT CHEAP
 

Doc Sprocket

*********
Messages
15,677
Reaction score
142
Location
Ontario, Canada
You might have jumped the gun by ordering up a custom sprocket before crunching the numbers...
It would help to have some info.
1)Max RPM?
2)Tire Diameter
3)Desired top speed
4)CVT ratios (top, mainly)
 

rootcory

New member
Messages
18
Reaction score
0
You might have jumped the gun by ordering up a custom sprocket before crunching the numbers...
It would help to have some info.
1)Max RPM?
2)Tire Diameter
3)Desired top speed
4)CVT ratios (top, mainly)


I ordered what I did because I was told by a member on here to add the tth3

4.5 and 4.5 together not multiply them !

8000 rpm

22 inch tires

The cvt is 1 to 1

I would like it to be snappy in the low end with a top speed around 50 to 60?

Right now. It pops wheelies!!!!
 
Status
Not open for further replies.
Top