I decided to do up an 8hp tecumseh snowblower engine, and maybe use it in my golf cart.
I was originally just going to check the insides out and paint it. I kept taking it more and more apart and stripped it right back to the block. I reseated the valves while I was in there (and had them out), sandblasted everything and repainted. Also covered over the holes where the old starter button was and the primer (Going to use a fuel pump, if I feel I need a primer i'll put one on the dash, probably use a sled primer in that case)
Anyhow, all looked good, and as I was putting the piston back in, I removed the rings to clean them. Unfortunately, I snapped the middle one.
I guess it's for the better, as I did everything else to this engine except rings and hone the cylinder.
Just wanted to share my little tale, and ask if anyone had any upgrades to do to this motor while I am ordering parts? It's an old 8HP tecumseh snowblower engine.
You can see the broken ring in the corner.
http://i.imgur.com/Q5VI0AR.jpg
I was originally just going to check the insides out and paint it. I kept taking it more and more apart and stripped it right back to the block. I reseated the valves while I was in there (and had them out), sandblasted everything and repainted. Also covered over the holes where the old starter button was and the primer (Going to use a fuel pump, if I feel I need a primer i'll put one on the dash, probably use a sled primer in that case)
Anyhow, all looked good, and as I was putting the piston back in, I removed the rings to clean them. Unfortunately, I snapped the middle one.
I guess it's for the better, as I did everything else to this engine except rings and hone the cylinder.
Just wanted to share my little tale, and ask if anyone had any upgrades to do to this motor while I am ordering parts? It's an old 8HP tecumseh snowblower engine.
You can see the broken ring in the corner.
http://i.imgur.com/Q5VI0AR.jpg
Attachments
Last edited by a moderator: