Hub and wheels

[slammedkart]

i need to get new wheels for my kart,
front and back.

i have a live axle its 3/4" think threaded on each end,
and i think the front is 5/8'' but im not sure.

i cant seem to find the right hubs can someone give me a link to cheap hubs for my setup?

by the way i can get pictures if anyone asks.

 

[Buick455]

Is it a 1" keyed axel with the 3/4" step down for the nyloc?

Get some pictures of the rear axel, front spindles and hubs. It will be easier to figure it out.

 

[slammedkart]

i am pretty sure its 1" keyed axle, but 1 inch from each end its threaded and a little less thicker (3/4")

i dont have a good enough ruler to figure the front out, its also threaded but a little bit thinner it was about 6/10 of an inch on my ruler.

i will get some pics up later on

 

[slammedkart]

i apologize for the ****ty cellphone pics, the rusted ones are the rear and the silverish ones are front. you get the idea

 

[Buick455]

Ok, well I can say that the rear is this axel or one very similar.

You can use these hubs depending on your wheels. Are you planning on using the rims/wheels you already have? If so get a picture of those too, or measure the pattern spacing. The above are 4 lug 4in spacing (8" golf cart rim basically)

The spindle was a little too blurry but someone else might be able to make it out.

 

[slammedkart]

im buying new wheels

i think the front is 3/4'' and threaded to 5/8''