how to hook up a clone throttle without modifying anything

Status
Not open for further replies.

Bluethunder3320

New member
Messages
5,677
Reaction score
39
this is delayed- it took me forever to hook up the throttle in the best way possible.

you will need:
bolt with a hole under the head (to crimp the wire)
throttle cable sleeve retainer (take one off a mechanical caliper)
throttle cable (for bike)
and then a pedal system, or for my bike i used a gear shifter from a mountain bike (cheap twist throttle!)

i suggest you go to your local bicycle store for the bits and pieces.

total cost: about $10, but could even be $5 if they are used parts.

here are the parts in pictures. basically you want to hook up the throttle like this, but instead of a brake arm, its the throttle control.


and here is my setup:


thanks! good luck with your throttle setup.

EDIT:
you will need a stronger return spring or add one like i did. loosen the nut on the throttle arm too.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
i will mention a sleeve retainer as you call it can be made very easly with an bolt, i would suggest a using center punch, i made one before i got a drill press or center punch, ruined about 5 bolts before i got it!
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
seems easier to me to keep the governor in, but i bet if you want to remove the governor you can hook up the push bar right on the place where the springs hook up to the lever. that way it just moves the carb valve directly. probably have to cut it down shorter though.
 
Status
Not open for further replies.
Top