How to fix a hard pull start

Status
Not open for further replies.

Bbqjoe

Banned
Messages
3,455
Reaction score
70
Location
Location, Location
This is only one method for fixing this problem, but it worked for me.
First remove pull starter assembly, and check for proper operation, might as well clean it while you have it out.

If you have broken your rope due to having to pull too hard, now would be a good time to replace that too!
If the pull mechanism is working, proceed to the next step.
Remove spark plug, and try to pull rope. If rope pulls easily, follow next procedures.

1. Remove exhaust.
2. Remove carburetor. Plug fuel line or drain tank.
3. Remove plug wire and plug(you've probably already done this, if
you put it back, pull it out again.)
4. Remove fuel tank.
5. Remove chain.
6. Remove drive assembly. (Jack plate, clutch, torque converter etc.)
7. Pull fly wheel.
8. Drain oil. (Do not discard in sink or sewer system. It is easiest to
put drained oil back into an empty container, and place on the
neighbors front porch while they are away.)
9. Remove mounting bolts from engine.
10. Carefully lift engine from mounting plate.
11. Place engine on work bench.
12. Remove side plate bolts.
13. Carefully remove side plate. (if you kill the gasket, stop right now
and order a new one.)
14. Carefully remove camshaft. (This is where your compression
release mechanism is located.) See pic #1. Yours may look
different, but most are located on the backside of the cam gear.


PIC #1


15. Obtain tweezers and small forceps, or small needle nosed pliars.

16. Remove all governor bits and pieces jamming up decompression
release. Now is also a good time to look for and remove all plastic
pieces and metal bits from crankcase and bearings. Bits should
resemble those in pic #2



PIC#2

17. Once you are certain that debris has been removed, look at the
other side of the engine. Locate governor shaft protrusion.
(Shown pic #3.)



PIC#3

18. Using a small punch or drift, carefully knock the governor shaft
and governor back through crankcase like you should have done
in the first place* when you disconnected the governor arm on
top of engine.

19. Plug hole, or re-seat the governor shaft only back into hole.

20. Mount, and reassemble engine. Don't forget to add new oil!

21. Engine is easy to pull start now. If not, buy preditor 212, and try again!








*Please note, Chancer is a really good guy, but sometimes gives really crappy advice ;).
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
I have it on Good Authority from "Bob58o" that...

Step 21 above is only half correct.

If it does not start return it to Harbor Freight and try again!
 
Status
Not open for further replies.
Top