How do you start 5.5 hp tecumseh

Status
Not open for further replies.

Amart2591

Trust me, I'm a Doctor
Messages
42
Reaction score
0
Location
JAX, FL
So I can't figure out how to get this engine going, I had started another thread but I can't find it now for those of you who had posts, sorry.

Here are some pictures, I would greately appreciate help!
 

Attachments

  • tecumseh 1.jpg
    tecumseh 1.jpg
    91.1 KB · Views: 12
  • tecumseh 2.jpg
    tecumseh 2.jpg
    98.5 KB · Views: 12

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
press the red push bulb on the carb 3-6 times and then yank the pull cord once or twice, if it dont start after 6 pulls, somethings wrong
 

Amart2591

Trust me, I'm a Doctor
Messages
42
Reaction score
0
Location
JAX, FL
I've tried turning it on already and its not cranking, I just got it checked out too. should the green wire in the picture be connected somewhere? Where is the killswitch?
 

buckeye

New member
Messages
105
Reaction score
0
Pull the plug and attach it to the plug wire. Ground it on the block to see if you even have spark. If not then just disconnect the kill switch completely and see if it has spark then.
 

j.concepcion54321

Rebuilding KTM, Need Kart
Messages
1,251
Reaction score
5
Location
East Providence RI
He means to take out the spark plug. After you do that leave it connected to the wire that goes to It (sparkplug). Then hold the spark plug in your hand and have someone else pull the cord to start the engine. If it has spark it will give you a jolt of electricity, nothing major. If it doesn't then something is being grounded somewhere. Post up a walkaround vid of the engine and all the wires. Also post your throttle, I've seen some engines that cut off the spark and turn it off when you let go of the throttle so you have to have the throttle pressed so that it runs. Take that vid and do the spark test so that we can determine your problem.
 

buckeye

New member
Messages
105
Reaction score
0
I think that wire is what your kill switch should be hooked to. So you may not have a kill swith wire in. What I was saying is, the spark plug wire. Take the spark plug out. Attach the spark plug to the spark plug wire. Set the spark plug on the block. Pull your starter cord. You should see a spark in the plug gap. No spark other issues. Spark, fuel issue. Make sense?
 

buckeye

New member
Messages
105
Reaction score
0
I wouldn't hold the plug in my hand. Let your buddy hold it. I meant to set the plug against the block. See my last post.
 
Status
Not open for further replies.
Top