Read it and attempted it with no success. Very irritating.
I lined up the arrow on the crankshaft with the mark on the cylinder sleeve perfectly (or at least I thought so). For the camshaft, I was as precise as possible at lining up those stupid lines with the cylinder head. I then, carefully slipped the belt on both gears and went through the whole process of scraping the old silicone away, sealing it up, putting a million screws back in, and the entire intake assembly only to have the recoil jerk back in to the engine as if there's no compression release mechanism (there is a release because 1. It's a residential mower 2. I saw it.) I am considering to pull the piece of crap apart again and try to find where I went wrong. With the exception of a few pictures on some replies to threads found on Google, there's no specific instructions or pictures on how to do this. In my opinion, it's a pretty stupid way of making timing marks when you contrast it with an OHV engine that uses a simple bevel in the gear teeth. Someone help?