How do I attach my kill switch?

Status
Not open for further replies.

CaptCanadia

New member
Messages
792
Reaction score
1
Location
Acton, CA USA
I just bought an on off switch from eBay and I'd like to attach it to my engine. I have a 6.5 HP Greyhound. Honda clone. I was looking at the switch and I've never done anything like this so I don't have a clue. Can anyone tell me how to hook it up?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
From everything I have heard- A momentary on the low oil circuit will work, and only requires one quick push. I have not experience with this, and therefore cannot trust this.

From what I KNOW for a fact- An on/off toggle on the kill circuit is dead reliable, and the only choice if you have no low oil circuit or have removed it. Do NOT use a momentary button on this circuit, you do NOT want to have to hold the button down until the engine stops completely if you're in a panic situation.
 

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA
From everything I have heard- A momentary on the low oil circuit will work, and only requires one quick push. I have not experience with this, and therefore cannot trust this.

You've got good reason to not trust that info, the single wire in conventional low oil sensor circuits dont have any type of relay or manual reset that would retain a ground signal with a momentary switch.

Connecting either type of kill switch to a functioning low oil sensor would give the same results as connecting directly at the magneto or tapping into the engines factory installed kill switch.

A momentary kill switches function would still be momentary no matter what, unless were dealing with some brand new type of engine I've never dealt with.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Sure enough, I know we've talked about it, and you did say it's working for you. I have not tested it, which is why I said,

From everything I have heard- A momentary on the low oil circuit will work, and only requires one quick push. I have no experience with this, and therefore cannot trust this.
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
I also have a momentary kill switch on my kart and with my 2 year old Tecumseh, I need to hold it down for AT LEAST 3 seconds or it WILL keep going. Especially if it's hot.

I would advise against them.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i used to have a press switch on my old 2 stroke bike i put together.

if you throttle it and hit the kill button rapidly you can make music :thumbsup:
 

CaptCanadia

New member
Messages
792
Reaction score
1
Location
Acton, CA USA
From the links this is what I learned.. I can just take the lead that goes into the factory kill and extend both the wires to the kill switch with one end of the wire on either end of the switch. This way all im doing is extending the wire and not really messing with anything. I'll have to have both switches on to start the engine, but if im in trouble I can just hit the kill and the engine will stop. Sounds simple, ya?
 
Status
Not open for further replies.
Top