Honda GX390 help

Status
Not open for further replies.

island

Guam U.S.A
Messages
75
Reaction score
0
Location
Guam U.S.A
Hi guys need help with my gx390. We were just riding it for about 30min then took a break tried starting it again wont start so i put it on choke started right up then when i took it off choke it dies, now it runs only with the choke on need help what is the problem?
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
sounds like its running lean? try balancing the choke between on and off, and see if it makes a diffrence, if so your running lean
 

island

Guam U.S.A
Messages
75
Reaction score
0
Location
Guam U.S.A
sounds like its running lean? try balancing the choke between on and off, and see if it makes a diffrence, if so your running lean

I tried that it just shuts off the choke has to be close completely then it will stay on. What is the stoke setting on the carb
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
not sure on the setting, is there anything done to the engine? performance parts or anything else? if not, trying actually cleaning the carb, if youve done somthing with the motor (exhaust, air intake) it could be forcing the motor to be to lean and not get enough fuel, somtimes you need to rejet, sometimes you dont
 

island

Guam U.S.A
Messages
75
Reaction score
0
Location
Guam U.S.A
No mods, I will clean the carb and i adjusted this black plastic screw cause it was dieing on idle
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Had very similar problem with a clone. In my case the main jet was clogged (accessed from the carburettor bowl).
 

island

Guam U.S.A
Messages
75
Reaction score
0
Location
Guam U.S.A
Thanks guys, The main jet was clogged. Now the problem is when i take turns or hit a bump the engine shuts off???
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
Is the low oil sensor still hooked up? (if equipped) If so, search the forum to find out how to disconnect it.
 
Status
Not open for further replies.
Top