Honda GX200

Status
Not open for further replies.

TorqueRanger

New member
Messages
257
Reaction score
1
I am running a brand new Gx200 honda and i want to do some cheap performance work .. Like adding a bigger and less restrictive air filter and a custom made header( but i am trying to keep it quiet as well ).. What else can needs to be done or what else can i do with out building a custom engine...But i want to know if i can get pics of everyone performance upgrades that they have done to this motor???


Thanks
Jason
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
With freer flowing intake and exhaust, you'll need to rejet the carb also. This can be done either by buying a new jet or drilling out the current one.
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
It all really depends. Some flow freer than others and require more fuel. I would suggest buying a mini drill set and slowly opening the jet one size at a time until it runs just right. From here you could just keep it or buy one of the same size that was actually made to that size and not drilled out.
 

DCProductions

Cockney Ragamuffin
Messages
496
Reaction score
0
Location
Louisiana, USA
Here's a bad picture of my engine (wish I had a better one- maybe when it was clean):


The mods I have on and in it are as follows
-governor removed
-18lb valve springs
-high flow air filter and adapter (UNI filter, aluminum adapter, 2x ABS elbows 2", hose clamps)
-high flow exhaust (3/4" 90 degree, thin-wall conduit curve welded to old flange; to keep it quiet, I also welded a 3/4" steel pipe coupling to the end so that I can screw on/off a briggs muffler.
-#90 main jet (this is the recommended size for light mods, but as redsox suggested, drilling it out appropriately would work better)
-18cc/GX160 head
-cut every other fan blade (not worth the extra rpm...)

Hope this helps!
 
Status
Not open for further replies.
Top