Honda GX110

[bhballs]

I just got (2) 3.5 hp Honda GX110 engines given to me.
I have a couple projects these will be perfect for.
The problem is that they have 17mm output shafts.
Does anyone know where I can get a clutch for these or how to modify one for them.

Thanks

BH

 

[chancer]

Are you sure? could be 5/8"

 

[bhballs]

I have to clean them up a little better. But first measurement today said 17mm. I will mic tomorrow and get back with the forum. Hondas web site said 17mm was an option for this motor.

Thanks

BH

 

[OzFab]

Hmm, 17mm may be a problem; to the best of my knowledge, clutches come in 1", 3/4", 19mm & 5/8", no 17mm...

IMO, the simplest solution is to machine the crank...

 

[Flyinhillbilly]

I have a 2:1 gear reduction off of a GX120 you can have if it will do you any good.

 

[bhballs]

The problem I see now is that the crank has no key way. It is just threaded on the end. Not sure on how to secure any clutch.

IDEAS?

Thanks

BH

 

[mckutzy]

These sound like a pump motor...
Better off getting a Pred motor and call it a day...

 

[chancer]

Idea...
Do not use this motor.

 

[Bunnypop]

Turn a sleeve with 1" od, thread the inside to fit the shaft and cut a keyway slot. Locktight, tack weld or pin it on.

 

[mckutzy]

Hello and welcome......

With that being said.... Lets hope he has a lathe, mill and/or machine shop and knows how to use it...... or finds a willing cheap guy to do it for him......

or buy a pred....