hemi or not

Status
Not open for further replies.

pearl111

Well-known member
Messages
1,166
Reaction score
434
Location
Baltimore, Maryland
Hi I just took the governor off the predator 6.5 engine I got last month. How can I tell if it is a hemi or not, and will this make a difference. Does it make a difference which type of gasckits to get for it. thanks for any info or help. mike
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
The easiest way it to look at the Valve cover.
Non Hemi is stamped steel
Hemi is cast aluminum.

The side cover for the gasket should be the same
 

itsid

Moderator
Staff member
Messages
11,563
Reaction score
261
Location
Ruhrpott [Germany]
Hi I just took the governor off the predator 6.5 engine I got last month. How can I tell if it is a hemi or not, and will this make a difference. Does it make a difference which type of gasckits to get for it. thanks for any info or help. mike

Sorry, I just want to be sure..

you took the governor OUT;
not just the governor lever OFF, right?

Since if you just removed the lever, but not the plasic wheel from inside of the engine,
then it'll likely shred and ruin the engine in short order.

Since you asked about gaskets (likely the sidecover gasket is what you're interested in)
I think we're safe.. but I'd rather ask to be sure ;)

'sid
 

pearl111

Well-known member
Messages
1,166
Reaction score
434
Location
Baltimore, Maryland
I did take out the plastic wheel and I will take out the arm. Then I will tap that hole and JB weld a bolt in place of that hole. Will a magnet stick to stamp steel, I guess it should if it is steel. Trying to see if its a hemi or non hemi. mike
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
Also see if you can read a part number on the Motor. The Hemi is 60363. Sorry I did not have that number this morning. But I do not know if it is on the Engine itself or not anyway.
 
Status
Not open for further replies.
Top