Help with throttle to governor linkage

[duhdewd]

Hello there. My kart has a B&S engine. I think the throttle linkage is missing a spring or something??? I can't find any diagrams to help me, but I need to see/know what is behind this picture.



The throttle cable moves the butterfly, which moves the butterfly, which moves the missing part, which pulls on the governor I assume. Right now, pushing the throttle does nothing to engine speed. Can somebody help me? Thx!

 

[t0x1k]

Dude, find a new image host or get banned.
Don't need porn pop ups.

imageshack.us
supload.com

 

[duhdewd]

Sorry... I honestly had no idea. Let me start over. Thanks:


Hello there. My kart has a B&S engine. I think the throttle linkage is missing a spring or something??? I can't find any diagrams to help me, but I need to see/know what is behind this picture.



The throttle cable moves the butterfly, which moves the butterfly, which moves the missing part, which pulls on the governor I assume. Right now, pushing the throttle does nothing to engine speed. Can somebody help me? Thx!

 

[motor_head]

need more pics realy can't tell any thing from just that one

 

[dcook3333]

That plate - the one where the throttle cable hooks to the "butterfly". On the other side of that plate should be an arm that moves up and down when the throttle cable is worked. Is it there? That arm would have a spring connecting it to the governor. One of those parts is missing.

 

[jimponder]

duhdewd- working on similar problem

I was wondering if you could help me out by taking a picture of the other side of that throttle setup you have- where the governor is. I just got a cart from a 'jerry-rigger' and need to see what it is supposed to look like so I can get it all back together properly. I'll need to order parts incase you have a good site to order them from...
-Jim Ponder

 

[solomon]

Why not just remove the governor and hook up the throttle straight to the carb?

 

[motor_head]

id say somebody bypassed the gov without removing the internal parts of it

 

[solomon]

yea, so you might as well pull the internal gov

 

[Linksep]

Excuse my ignorance, but it's been a long time since I've been inside a small engine. Why remove the internal parts of the gov? Do they tend to shrapnel inside the motor at too high of an RPM?

 

[solomon]

yea they can explode at just over 4000 rpm

 

[JMAN]

ohh

I am actually having the same issues with the same engine. But I am also lost on the other controls and how they hook up. The choke and rev. all wires were taking off and I am unable to find pictures that show how it all hooks up.

 

[solomon]

thier should only be 1 wire, that's the kill wire. Is this engine on a kart? if so just pull the gov and hook throttle directly to carb

 

[Russ2251]

Probably has an alternator for starter and/or lights.

 

[gabeboucher]

do you have any other pictures of your carb governor setup. I have same engine and a heck of a time getting that put together.

 

[souperman000]

do you have any other pictures of your carb governor setup. I have same engine and a heck of a time getting that put together.

dude, look at the date, this thread is more than 2 yrs old. That guy nhasnt been active for a long time. Either PM him and you might get a response or start your own thread to ask your question there

 

[redrocketship]

I too am having the same issue figuring out how to hook it up. Does anyone have pics or a drawing of how it all hooks up?
Thanks!