help with 49cc engine please

Status
Not open for further replies.

wavboy

New member
Messages
24
Reaction score
0
Location
hot springs
i have a 49cc pocketbike ok this is wat happens punp the gas into the carb spray starter fl pullstart it it start pull down the choke pull the throttle and it dies ok this another method i tried i pour gas down the sparks plug hole start it i get on pull the throttle and take off about 10 ft or so and it dies tell me wat u guys think do i need a new carb or wat please let me know wat u think
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
Sounds like a carb problem, however I cant say for sure if it just needs adjusted, or taken off and cleaned.
 

augidog

New member
Messages
329
Reaction score
0
check your mixture setting:
run the mixture screw all the way in until lightly seated (count how many turns it took as a clue), screw it back out 1 3/4 turns...that puts you at a good starting point, you'll prolly end up slightly leaner (screw in) by the time you find the sweet spot.
 

Mrrcarney

New member
Messages
43
Reaction score
0
i have a 49cc pocketbike ok this is wat happens punp the gas into the carb spray starter fl pullstart it it start pull down the choke pull the throttle and it dies ok this another method i tried i pour gas down the sparks plug hole start it i get on pull the throttle and take off about 10 ft or so and it dies tell me wat u guys think do i need a new carb or wat please let me know wat u think

these things need to be steaming hot before they will go

start it hold the rear wheel up and slowly increase the gas

adjusting the choke as needed when you have about 3/4 open choke and can go from idle to full throttle without bogging down

drop the rear and hop on

works like this on mine
 

wavboy

New member
Messages
24
Reaction score
0
Location
hot springs
thanks guys will try everything

before posting this on here i did take the carb apart and clean and trying to get that sucker hot wont even stay started but the mix scew i did not try were is the mix screw on the carb thanks let me know wat else u guys think:thumbsup:
 

augidog

New member
Messages
329
Reaction score
0
pictures help

how about a pic of your engine? if the mixture screw's not evident, you may not have the engine i'm thinking of.

this is a 49cc, it has a diaphragm carburetor, and the mixture is adjusted with a screw on the side of the carby:
49cc.jpg

this is a 47cc, it has a bowl carburetor, and the mixture is adjusted by changing the position of the clip on the needle:
47cc.jpg
 

robbie

New member
Messages
857
Reaction score
9
Location
Osceola, Missouri
You're not getting gas to the carburetor. Check for cracked lines. If you have a diaphragm carburetor, you may have a hole or crack in the diaphragm. If you have a float carburetor, the needle may be stuck.

Or, your shutoff valve may be closed, if there is one.
 

wavboy

New member
Messages
24
Reaction score
0
Location
hot springs
i will post pic of the engine or mabe even a video si u guys can see wats going on:iagree: i hav the first engine 49cc thanks for the pics
 
Status
Not open for further replies.
Top