Help on new 2 cycle motor

Status
Not open for further replies.
S

stormsgate

New member
Messages
27
Reaction score
0
I have a new 2 cycle motor. Yesterday was the first day to run it. Instructions say use 25:1 oil mix in the 2 cycle engine. Yesterday it ran great.....ran it for about 20 min off and on. When i came back to crank it (Pull start) it would not run....so I bought a new plug and after awhile it cranked. Then this morning it wont run......it also wants to kick back some...what do you think it is? Why wont it crank now? Am i flooding it or what?
 
Doc Sprocket

Doc Sprocket

*********
Messages
15,677
Reaction score
151
Location
Ontario, Canada
What is the implement? Have you followed the starting and operating instructions exactly, and measured the oil accurately? Did you mix the oil/fuel well BEFORE filling the tank?
 
S

stormsgate

New member
Messages
27
Reaction score
0
yes......and just got a new spark plug again.....i saw no sparks in the dark when i was pulling the cord but I accidentally touched it and it shocked the heck out of me......shouldn't i see sparks in the dark around the spark plug when i am pulling the cord and plugged in and when pulling the cord?
 
Doc Sprocket

Doc Sprocket

*********
Messages
15,677
Reaction score
151
Location
Ontario, Canada
You're only going to get a spark with the plug NOT screwed in IF you hold the metal part of the plug against a clean, bare metal surface on the engine block.

What is the implement?
 
S

stormsgate

New member
Messages
27
Reaction score
0
toystory_4wd said:
You're only going to get a spark with the plug NOT screwed in IF you hold the metal part of the plug against a clean, bare metal surface on the engine block.

What is the implement?
Click to expand...


whelp....I'm getting a spark then...lolol. Thank you!! That was very much needed information:thumbsup::thumbsup:
 
Status
Not open for further replies.
Top