Help needed 8.5 Briggs and Stratton

Status
Not open for further replies.

Vsproject

New member
Messages
4
Reaction score
0
Ok so I have a b and s 8.5 HP engine off a ride on did heaps of research to convert from vert to horizontal went to do it and realized its a synchro balanced engine I've read that by just topping up the oil the standard oil slinger may do the job but would love any advice people could give me I've already started moving the carb and fuel tank and was trying to source a dipper maybe I just source a new engine?
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i was going to that to a 13.5 briggs. with the mechanical balancer. but i couldnt find a way to make a dipper that cleared it. extra oil will find its way out, i wouldnt do that.

i ended up just putting it together as a vertical shaft, running it, it ran like crap so i stripped it down and scrapped it.

i also tried to convert a 5.3 tecumseh but it had an aluminum flywheel and never ran for more than a few seconds.

youll save a ton of headache if you look for a horisontal shaft engine. predator engines are $100 at harbor freight, or check craigslist
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
ive also got motors from mower shops. check around. i got a horisontal 8hp briggs for $50 that came off a junked snowblower
 
Status
Not open for further replies.
Top