having problems with a 1004 gtc torque converter

Status
Not open for further replies.

coolspot

New member
Messages
7
Reaction score
0
hi guys i am having a problem with a gtc torque converter i have fitted it all like they say and they will not line up and its because of this bit on the plate but you have to have the bit on there so i dont know what to do? any help would be good thanks.
 

metalthrashinman

New member
Messages
279
Reaction score
0
Location
Hope, NJ
Do you mean the spacer that goes on the engine crankshaft that goes on before the drive pulley? You may have to modify it to make the pulleys line up. I had to take mine to the grinder and make it much smaller (thinner).
 

coolspot

New member
Messages
7
Reaction score
0
the driven bit is the problem on the plate it has a bit that sticks out 4" before you can even put the bits on and it makes the bits not line up
 
Status
Not open for further replies.
Top