Hammerhead 250SS - NO SPARK

[pineyrockridge]

Have 2007 Hammerhead 250SS (CF250). Running fine, then stopped. No spark. Ran through write up found on this board for no spark on CF OR cn 250, checking the inputs/ouputs to/from the CDI (DC) according to that write up.
CDI Pinout
1 - From trigger wire
2 - To ignition coil
3 - Ground
4 - Nothing
5 - Kill Switch
6 - DC Power from the ignition switch.
All checked out. Checked trigger and getting .1 v, when starting. All seems to work out.
Replaced CDI, and still no spark.

Any Ideas, at my wits end.

 

[Denny]

Have you tried replacing your spark plug?

 

[pineyrockridge]

Yes, twice

 

[Savage3]

Have you tried replacing your spark plug?

Have 2007 Hammerhead 250SS (CF250). Running fine, then stopped. No spark. Ran through write up found on this board for no spark on CF OR cn 250, checking the inputs/ouputs to/from the CDI (DC) according to that write up.
CDI Pinout
1 - From trigger wire
2 - To ignition coil
3 - Ground
4 - Nothing
5 - Kill Switch
6 - DC Power from the ignition switch.
All checked out. Checked trigger and getting .1 v, when starting. All seems to work out.
Replaced CDI, and still no spark.

Any Ideas, at my wits end.

What type of meter did you use to check trigger? The signal is too fast to obtain an accurate reading on a regular DVOM.

Did you check the air gap? Is it fixed?

Have you checked the coil?

 

[Rat]

Did you check the plug wire ends to make sure it's seated fully? I cant count how many times Ive seen an HT disconnect from either the ignition end or the boot end for one reason or another