Nissinator1996
New member
- Messages
- 54
- Reaction score
- 0
I have a gy6 150 but the ppl before me messed up the exhaust on the case so how do I mount it.....jb weld???
Gy6 150
- Thread starter Nissinator1996
- Start date
- Status
Doc Sprocket
*********
Sure... Maybe. Pics?
Nissinator1996
New member
- Messages
- 54
- Reaction score
- 0
the holes on the engine block where the exhause mount is....is messed up someone broke bolts off in it and the tried to drill a separate hole so instead of have 2 holes it has 3 holes
klicky96
New member
Use an easy-out bit to pull those broken bolts out.
Doc Sprocket
*********
I'll second that. It's extractor time!
klicky96
New member
yeah, if you try to drill and tap new holes in a head when your not too experienced, you can really mess it up.
rickyp8888
New member
its not going to be as easy as an bolt extractor seeing as they are studs and im pretty sure they are pressed in. so I say drill out the studs and use heli coil for new threads
Doc Sprocket
*********
I have never seen exhaust studs that are pressed in.
klicky96
New member
Neither have I, Toystory, neither have I.
Doc Sprocket
*********
Right. AND- stud or bolt, an "easy out" (extractor) works the same way. Annnyhoooooo...
Nissinator- let us know how it turns out.
Nissinator- let us know how it turns out.
klicky96
New member
Remember that post where ya'll were asking everyone what they would like on the forum? Well, lets add a like button! I would like that post ha.
Doc Sprocket
*********
Closest we have is the "thanks" button. IMHO, has the same effect.
Jake.B
New member
Yeah never have i seen pressed it exhaust studs. They break from rust most of the time. Just a peice of advise with the ez-out. If you have never used One before its a good idea to practice or ask i trusted friend or whatever that has.. You can ruin all your chances of getting it out (besides drilling) if you mess up to bad.
- Status