gx200 head

Status
Not open for further replies.

verdebmxer47

New member
Messages
33
Reaction score
0
Location
Sioux Falls SD
i pulled a 22cc head of one of my clone motors to practice some porting and i didnt plan for the porting to turn out as good as it did. i dont want to just throw it in a box and not use it, but is it worth putting it on a gx160 with an 18cc head on it? are there any advantages to a 22cc head over an 18cc? i was practicing because i wanted to get a 14cc head and i dont want to ruin it by going too far with the ports. i was thinking about just milling the 22cc head but it would be cheaper for me to just buy a 14cc head.

I also have a stock predator that i was thinking about throwing this head on there but still not sure if i should put a smaller head on that too.

Please let me know what you think. Thanks
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
I can't think of any advantages but, I can think of a disadvantage or two to fitting a 22cc head in place of a 18cc head...

My best advice is put the head back where it was & call it practice/experience...

As for fitting it to a Predator, I'm unsure if that's even possible as the Predator is not a Honda clone...
 

ITURNLEFTANDRIGHT

Go Kart Guy from Toronto
Messages
1
Reaction score
0
Location
Toronto
Honda and Honda clone heads fit on a predator and predators fit on Hondas or clones. What you need to remember is to keep the push rods together with the original heads, some have longer push rods. If your push rods are too long or short, the valve train geometry will be off and you can run into problems rather quickly.

In these small engines, compression is king. Now that you have learned how to do the porting and polishing, go with the 14cc head and a stud kit for the head. Make sure you use a torque wrench and tighten properly (17lbs I think, double check that though). The most important thing to do with these heads is to increase velocity not necessarily C.F.M.. A 3 angle valve job does a lot, trust me. Neway valve cutters are expensive but if you can find one for $100 its worth it.

If you want, find someone to "skim" your 22cc head down a bit to increase compression, you may need to get shorter push rods if you over do it. There are videos online on how to do it yourself wit sandpaper, a very flat surface, and a lot of time but find someone with a milling machine and have them skim it ($25-40).

The "HEMI" predators are the only one that has the same cam shaft journal as the Hondas or clones they also come with a nice head and a flat top piston. If you go this route and put all of the clone or Honda parts in the pred (crank, cam, piston, flywheel) go with a longer rod +.20 or +0.40 rod to make up for the shorter stroke.

You can also put the crankshaft, rod, head from the hemi predator into the Honda or clone 196cc block and make a stroker (watch your spark plug clearance though).

Nice work so far.
 

verdebmxer47

New member
Messages
33
Reaction score
0
Location
Sioux Falls SD
Thanks a lot! super helpful info

---------- Post added at 12:16 PM ---------- Previous post was at 12:12 PM ----------

and on that note. I heard that with the stud kit you dont have to run a head gasket? is that true? im doubting it can work without leaking somewhere.
 
Status
Not open for further replies.
Top