Gx160 help with idle

Status
Not open for further replies.

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Hi,
Got a small problem with my gx160 after installing a gx200 carb and thinner head gasket-
Seems to run fine in the higher revs (2500+) except for some governor spring trouble (I think I will just rip it out)
However, at low rpm, the idle hunts around, and only runs partially choked. I tried fiddling with the brass idle mixture screw, but no joy. Could it be an over lean idle jet, or maybe the compression release on the cam playing up? I can try the original carb again if need be.

I think I am going to just rip out the governor, and make a linkage directly to the carb. Then tune the carb to run correctly. Sound like a plan, or should I try something else?

I want to rip out the governor because the spring has been over stretched and it doesn't function correctly.
Thanks
Rob
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
I would rip the governor and tune from there. No point in getting it running perfect just to find removing the governor makes it run like crap again.

Good luck!
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Thanks. Nice to have another opinion.
I Should probably regear after doing the governor. I sh!t myself going any speed on a mini bike :p
Anyone got some good throttle ideas using stock parts?
Edit: found some ideas.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Pretty sure! I will check though.
I think I stripped some threads to mount the blower housing, what is the best way to repair these? Helicoils? Or just tap one size bigger and use larger bolts.
 
Status
Not open for further replies.
Top