governor remove & oil sensing unit ?

Status
Not open for further replies.

pearl111

Well-known member
Messages
1,166
Reaction score
434
Location
Baltimore, Maryland
Hi, I have checked out the way to take the governor out of my 6.5 predator engine. Do I need to take the governor arm off that is left hanging inside the engine. And if I take out the oil sensing unit what do I do with the wire that went to the unit.
 

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
73
Location
White Settlement Texas
Hi, I have checked out the way to take the governor out of my 6.5 predator engine. Do I need to take the governor arm off that is left hanging inside the engine. And if I take out the oil sensing unit what do I do with the wire that went to the unit.

Leave the sensor use the wire for a kill switch or just wrap it in electrical tape so it can't ground out. (As soon as it touches ground...it'll kill the engine.)
 

Jrgunn5150

Rudderless
Messages
1,028
Reaction score
12
Ok thanks do I take the governor arm out that is inside the engine after I take the governor gear out. mike

I did, I had to rotate the engine about a bit to get it down.

Then, i put a 1/4-20 bolt coated in JB Weld in the hole.
 

pearl111

Well-known member
Messages
1,166
Reaction score
434
Location
Baltimore, Maryland
Hello again I am sure this question has been ben asked before I could not find it. I took the governor out of the predator 6.5 I will get the muffler gas jet and air intake up grade do I really need a fly wheel up grade also. thanks . mike.
 
Status
Not open for further replies.
Top