Governor removal

Status
Not open for further replies.

jasonl

New member
Messages
3
Reaction score
0
When removing the governor, is it necessary to remove the internal arm? I've seen info on both, removing and leaving it in there.
 

colinm

New member
Messages
20
Reaction score
0
Location
Northeastern Ohio
I would just disconnect the linkage (usually just a piece of wire) from the governor arm to the carburetor throttle arm.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
If you're going to defeat the governor, it is best to remove all internal components. There is a possibility of internal problems with the governor when over-revved.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
On a side question since this is about governor internals.. am I the only one who is mind boggled about how 2 weights less than 5 grams each can overcome the tension of the governor spring? Think about pulling back on the spring. The tension seems like a lot for the governor to "push" the flapper. Then again at 3000 RPM I guess anything is possible lol.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Those little flyweights have a fair bit of leverage on the arm. They don't have to move the plunger very far, and the arm that they act upon is 1 1/2 - 2" long. From there, the external arm really only has to alter the spring tension, and not by as much as you might think. When you play with it by hand with the engine running, a lot of what you feel is actually fighting what the flyweight is doing. Think about the leverage in reverse, like trying to push a car that's in a low gear.
 
Status
Not open for further replies.
Top