Governor on 5hp Honda engine

Status
Not open for further replies.

rifkin

New member
Messages
66
Reaction score
0
I have no idea but I do know pre or post 2011 manufacture makes a difference.
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
the silver arm coming out of the engine block connecting to the carb is the governor arm. You can bypass the governor by connecting the throttle linkage directly to the arm if you do not wanna take the complete governor out. Otherwise, you can take the side case off and completely take out the governor.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i havent had an issue bypassing the governor, ever. my friend ran a bypassed clone on his kart for a year so far and no problems.

if you want to be sure that there wont be an issue then you need to open the crank case, remove the plastic governor gear and find a different way to set up a throttle.

heres how i did one.
http://www.diygokarts.com/vb/showthread.php?t=15203
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
5hp honda what?
It makes a difference. It should be quite obvious if you take off the sidecover. There will be a little nylon gear somewhere inside. Usually either on the sidecover or at the back of the block.

Remove it and all internal linkages.
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
I have never actually taken my governor out, I have always bypassed the governor because it still pulls back when I release the throttle. If I have a spring-loaded throttle pedal then when I release it, It will put some slack in my throttle cable, and the governor will still close the throttle. Yes, you can take the governor completely out. IMO, that could be a lot easier to a point. But I've always used my way just because I believe it will be safe enough for me to ride it a while.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Valve spring bounce will limit rpm, and if you have the stock muffler and air filter, that will too.
 
Status
Not open for further replies.
Top