Got a weird Gx question

Status
Not open for further replies.

gixxerkart

Big Boss
Messages
240
Reaction score
0
Location
high desert
Engine starts first pull, full choke, gas lever on. I let it run like this til warmed. When I start to turn the choke off this thing acts like the throttle is pinned. I back throttle off and it dies. Half choke is ok. But choke moved fully to the right and it will not idle and as it is moved to the right is when the rpms increase. Wtf?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Could be a number of things. Have you had the carb off? It's possible you installed the isolator and/or gaskets upside-down, backwards, or missing. Check gaskets for integrity, could be leaking.

Your idle setting could be way off, partially fouled idle circuit, governor out of adjustment...
 

gixxerkart

Big Boss
Messages
240
Reaction score
0
Location
high desert
It's never been apart. The carb is very dirty though.i looked for the idle screw but couldn't find it... Any one wanna post a pick? It's up top by the fuel hose connection right?
 

gixxerkart

Big Boss
Messages
240
Reaction score
0
Location
high desert
Ok. I turned the black plastic screw. It made no difference at. It didn't increase or decrease anything? I thought the idle screw faced upward on the carb? Not that big sideways screw.
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
Its only running slow fully choked because it has no ability to run faster with that restricted flow. When you move off choke and add air to the mixture it picks up tempo and tries to run at the massive idle speed you've got it cranked up to. If you turned the idle down the engine wouldn't be able to run. The carb is still very clogged up and may need replacing.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
IF you have an idle mixture screw, you'll likely find it on the left hand side of the carb (facing the choke plate) very close to the mounting flange. Brass screw- IF you have. Many carbs no longer do, due to EPA, CARB, or some other fanatical group of tree-huggers.
 

gixxerkart

Big Boss
Messages
240
Reaction score
0
Location
high desert
Dang tree huggers. Ya I'm not seeing a idle screw and it is a fairly new Honda. Guess its new carb time. Any suggestions on where to buy cheap? Also can I upgrade carbs and stay stockish( muffler and filter come later)
 
Status
Not open for further replies.
Top