Good deal?

Status
Not open for further replies.

bkrider113

New member
Messages
33
Reaction score
0
so wait if its a full running kart that needs a lil welding I think its a good deal and would jump on it. If it needs brakes ect... like more than $100 of work I wouldnt jump on it
 

hd4ou

New member
Messages
76
Reaction score
1
I would think a good running 11 hp honda is worth the money by itself.
 

FLkid92

New member
Messages
52
Reaction score
0
im goin to pick it up hoepfully today being that thats around as much as i was going to spend just getting my frame to a rolling chassis so with this ill have everything i need and just have to weld and make a motor mount for that 11 hp honda :D
 

FLkid92

New member
Messages
52
Reaction score
0
bought it i think i got a pretty darn good deal came with a brand new 40 series tav just need to get the right sized belt the engine looks good just gotta put the tank on and hook up the carb and stuff came with the roll bars an extra set of sweet looking tires and a super comfortable seat lol Ill have pics up in the photo gallery section in the thread titled yerf dog project
 

FLkid92

New member
Messages
52
Reaction score
0
tav belt

ok so i measured the center distance and the driven unit. the driven unit is 7 1/2 inches and the center distance is 9 inches so does that mean i could use the 9 3/8 or 9 3/4 belt ?
 

hd4ou

New member
Messages
76
Reaction score
1
might remeasure and get a more accurate measurement. Your 7 1/2 inch doesnt seem right and neither does the 9.
 

Kart builder39

New member
Messages
35
Reaction score
0
take the widest tabe mesure you can find (1in) and mesure it as if it was the belt and give your self an other 1/2 in in slack and thats how long your proper belt size is
 

FLkid92

New member
Messages
52
Reaction score
0
take the widest tabe mesure you can find (1in) and mesure it as if it was the belt and give your self an other 1/2 in in slack and thats how long your proper belt size is

ill have to try that hopefully this darn rain will pass over so i can weld the motor mount and get that engine on there
 
Status
Not open for further replies.
Top