go cart on the cheap!

Status
Not open for further replies.

jeepinreo

New member
Messages
4
Reaction score
0
Okay this is my first post! I am a fabricator/welder for a living so making the frame will be a cake walk for me.. I am building a gocart on the cheap, its spring clean up and i scored a good running tecumseh 8hp vertical shaft motor, and have a old craftsman mower i can get. i plan on taking the steering components off of that.. can i use the mowers transaxle and just swap to a smaller pully gear and weld the spider gears up?:auto:
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
I'm planning the same sort of thing but it's more like a mini buggy than a go kart. The reason for that is the extra space it will take to house the engine & trans (I'm using an 11hp & widening the trans by about 30"). Then there's the problem of the clutch; what to use, how to set it up properly.

In saying that, it must be possible; look at all the racing mowers out there.

Plan everything carefully; the size of the kart you'll need means a lot of weight, can an 8hp handle it? Also consider centre of gravity, the higher it is the more likely it will roll
 

jeepinreo

New member
Messages
4
Reaction score
0
it was my lucky day! tore the engine apart to find out its a horizontal, durrr i should of know that! anyways i have a few pictures here. take a look at this shaft and let me know what you think, and if ill have problems with a clutch or not.... its a 7/8 bore. Also it would be sweet if i could use the snowblowers tires to! i am looking at around this size, just need to figure out my gearing, would like to climb some hills and be able too go about 30.




p.s im going to use round tubing just becasue it looks so much cooler! :thumbsup:
 

Jake.B

New member
Messages
495
Reaction score
0
Location
California-USA
Id go with a torque converter. If you want 30mph and hill climbing, 8hp may be ok depending on weight but I would definantly check them out. There is lots of info on the forum.
 

jeepinreo

New member
Messages
4
Reaction score
0
well since i can only get one clutch for the 7/8 engine i would have to run a belt to a jack shaft, then use a chain to the axle... and the clutch is a 3" what size pulley would i want to have on the jackshaft?
 
Status
Not open for further replies.
Top