Give me some feedback here.

Status
Not open for further replies.

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
Alright, I was gonna rebuild this engine but found out it will cost me $600 alone in just parts. I looked around my garage and found a few engines laying around. So I'm thinking, if I put a 6.5 Honda Clone on it, it should run pretty good, right. It was originally a 125cc so I think it would run good. What do you guys think?

1983 Suzuki LT125 Quadrunner.jpg

This is the engine I would be putting on it.Honda Clone.gif
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
I'm gonna use the gearbox off of the actual motor that came off it if I can. I started tearing that motor down yesterday to rebuild it, but when I found out today that it will cost me over $600 just for parts, I said screw that haha.
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
I was gonna cut the mount-bar for the old engine. It isn't supporting anything. All it was used for was mounting the engine. If I cut that out, I can fit my engine right in, mount a plate to bolt it down, mount the gearbox, and be done.
 
Status
Not open for further replies.
Top