General Engine Troubleshooting

Status
Not open for further replies.

karl

Well-known member
Messages
2,449
Reaction score
719
Location
North east Ohio
This is my guide for getting an 4 STROKE engine to run. There are tons of threads saying my engine won't start so do these steps first.

If your engine won't start do these steps.

1. Check for spark.
2. Clean or replace spark plug.
3. Unplug kill-switch

If it still won't start

1. Try a shot of gas in the carb
2. Disassemble the carb and clean it with carb cleaner or kerosene.

If it still won't start

1.Check compression.

If compression is low, It is usually because

1. Scored piston
2. Worn piston rings
3. Valves not sealing
4. Stuck valve

To solve these,

Scored piston= Top end rebuild, usually not worth it.
Worn Piston rings= Replace the rings and maybe hone the cylinder.
Valves not sealing= Lap the valves
Stuck valve= Tap down Valve with a mallet and use alot of oil.

That should get most engines started again.
This is a basic guide, so try this before you post a thread saying my engine won't start.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Not a bad start. You should make mention of the coil and points (if applicable), as well as checking ignition and valve timing. As we all know- for combustion you need air, fuel, compression, and spark- but EVEN with all four, a serious timing issue (esp ign.) will prevent it from running.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
True enough- But identifying a shorn key or bad coil are pretty basic things anyone can do. Same with valve timing check if the engine's open and you're looking at a valve job, etc.
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
We should make a flowchart for people to diagnose engine problems. Mabey for "dump gas in carb", you should say "if it starts, then dies, then clean carb".
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
I can make a flowchart. I have software that will do it. Now, we need to agree on what it ought to say.
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
 
Status
Not open for further replies.
Top