Gear ratio question

Status
Not open for further replies.

don319

New member
Messages
2
Reaction score
0
Location
I meant to put don3194
A few years ago we bought this go-kart, and it works just fine. The only problem is the place we drive is level, but has so many ruts, divets, and rocks it is almost impossible to ride there. We are trying to look for new tires and thought that at least 20" tires would work. We currently have 16" tires on it with a compouned gear ratio of 10:1, engine turns ten times for one revolution of the tires. The go-kart has a 6.5hp engine with a 12 tooth clutch going to a 24 tooth sprocket on a separate shaft with the other side having a 12 tooth sprocket going to a 60 tooth on the axle. Would the 20" tires still get me up a steep hill to the road?
I would send a picture, but since we have no computer at our cabin, there is no way it will happen.
 

anickode

Active member
Messages
2,296
Reaction score
77
Location
S.E. Michigan
:iagree:

But try it out and see. That 24t would be easy and cheap enough (compared to replacing the axle sprocket) to swap out if you wind up needing more torque.
 

itsid

Moderator
Staff member
Messages
11,563
Reaction score
260
Location
Ruhrpott [Germany]
Switching from 16" to 20" will cost you 25% of the torque you had with the 16" tires.
finally... THANK YOU!

yes, you'll loose ~25% of your torque (rolling tyres are never a perfect circle.. never mind!)
SO in order to keep the torque you had, you'd want to get them back by adjusting the gear ratio (increase by 25%) so you'd end up with 12.5:1
(means a 30T Jackshaft input sprocket instead of your 24T will do the trick)

'sid
 
Status
Not open for further replies.
Top