free lawnmower

Status
Not open for further replies.

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
well i got her running and shes running good, i have it without a primer bulb right now, so it takes a few pulls, but its great
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
the main jet and over it, because in both this main jet and the e tube, the e tube was clean, but in the top of the main jet its a big hole followed by a tiny tiny hole, so i put off a thing of bread tie, pushed it through the little tube next to the e tube and that little jet. and it ran. i have noticed, that it needs a prime to get her started when shes really cold, and i havent put it back on yet, how exactley does the primer work? because it runs through the breather hose from the air filter, but thanks toy story and everyone else for the help
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
that was doing weird stuff. LOL.

too bad my 6hp briggs has a tapered shaft.

Better yet! It doesn't have any immediate kart value so if you butcher it, it's not like an immediately usable engine was trashed. If it does work, get the PTO lathed or get a straight one.
 

sideways

Unfinished projects king.
Messages
1,501
Reaction score
2
Location
Perth, Western Australia
I just cut it out of a piece of steel plate. Probably 2.5mm thick.

I made a few mock ones out of tin first, when I was happy with the design I used it as a template for my final one.
 

oscaryu1

New member
Messages
2,767
Reaction score
7
That dipper's gonna bend so **** easily at high revs... I'm putting money that motor'll blow in a couple days.
 

karl

Well-known member
Messages
2,449
Reaction score
719
Location
North east Ohio
That dipper's gonna bend so **** easily at high revs... I'm putting money that motor'll blow in a couple days.

Oil harden it with some used motor oil and a torch, then temper it by heating it up again, but not as hot and let it cool.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
you think a 5hp briggs dipper would work?

well mines a taper shaft, pulley is rusted on good, and it has a slight wobble.

EDIT: also it would make the dipstick horisontal and it would definately leak out the worn seal.
 
Status
Not open for further replies.
Top