Flooding Tec HS50. Fuel pump added.

Status
Not open for further replies.

Thrllskr729

New member
Messages
2
Reaction score
0
Location
Michigan
I had to move my gas tank lower and therefore needed a pump but now it floods out. The engine was on my snow blower for years and ran great with the tank mounted normal and being gravity fed. So I replaced the carb with a brand new one thinking it was a worn float needle/seat. Still floods. Are these carbs just unable to hold back pump pressure? My pump is the square single outlet type. A cheap mikuni clone.
 

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
73
Location
White Settlement Texas
Simple answer....yes...the added fuel pump is supplying too much pressure.

You could pipe it up to a smaller supply tank...(with a return) ...and let gravity take over from there...or figure out how to reduce the pressure...
 

Thrllskr729

New member
Messages
2
Reaction score
0
Location
Michigan
I added a valve to the vacume line to try to adjust pressure and it works... Sorta. It'll run great for a while and then either flood or lean out. It's inconsistent. Think I'm gonna try a return line.
 

2SlickNick

American Minibikes @ FB
Messages
2,758
Reaction score
33
Location
Mesa, AZ.
As Doug said...
Yes as a return line to the tank. Put a "y" or "t" in the line supplying fuel to carb and have other line rerun to tank. That should resolve that... I and others have done the same with success.
 

anderkart

Moderator
Messages
6,432
Reaction score
393
Location
Surprise Arizona USA
I added a valve to the vacume line to try to adjust pressure and it works... Sorta. It'll run great for a while and then either flood or lean out. It's inconsistent. Think I'm gonna try a return line.

Good Idea, but remove the valve from your pulse line and reinstall it somewhere in your return line so you'll be able to easily reach it for adjusting fuel pressure while driving.

Here's a pic of my old karts setup, I used a 1/4" Briggs In-line fuel shutoff valve in my return line. I also installed a marine squeeze bulb in the supply line so I could prime the whole fuel system for 'one pull starts'.

PS:
Using clear fuel line really helps out in letting you know whats going on in there too. Don't worry if you see bubbles develop in the pressure line, that's normal and not a problem :thumbsup:
 

Attachments

  • beisse fuel pump plumbing 011.jpg
    beisse fuel pump plumbing 011.jpg
    333.2 KB · Views: 7
Status
Not open for further replies.
Top