First time welding and working on small engine.

Scotty moses

New member
Messages
15
Reaction score
12
It's got some jam that's for sure . I put a centrifugal clutch on the first attempt and I could barely get the thing to move. I didn't know about the sprocket sizes and what have you but now I got it figured out thing goes pretty good. thanks for asking
 

Denny

Canned Monster
Messages
11,620
Reaction score
8,054
Location
Mayberry, Indiana
Looks good. The only thing I would do different would be to run a diagonal piece from the top of the shock mount to about 18” forward.
 

milesguy81

New member
Messages
29
Reaction score
15
Location
Somewhere in Utah
Woa whats that little tube coming out of your air filter? Is that a NoS hookup or something? If it is does anyone know if there's actually power gains from that for the price, like the 6 sigma one on Amazon
 

Hellion

Moderator
Messages
8,524
Reaction score
3,619
Well I don't like that angular exhaust header. :furious2:

That's my constructive criticism for the day. :cornut:
 

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,830
Location
Chicago-town USA
Actually my eyes are trained to spot dropped nuts, bolts, springs, pins, clips etc.
that fine trait, comes from years of crawling around looking for those kinda things.
lol. When I drop things I close my eyes and listen. Apparently, I’m a bat cause my sonar works better than my eyes for dropped hardware.
 

Denny

Canned Monster
Messages
11,620
Reaction score
8,054
Location
Mayberry, Indiana
Poor buck! I’ve seen them loose legs in barbed wire fences before but not those!
That hurts too much to even look at!
 
Top