Faster gx160?

Status
Not open for further replies.

Dazv

New member
Messages
31
Reaction score
0
Location
England
Hi guys
So I've had my kart up and running for Afew months now and really enjoying it but I'm now looking for a bit more speed. I've got a 15 tooth clutch and 90 tooth spocket to make it 6 to 1. Is there and way to get a bit more speed other than changing the spocket which could ruin my clutch???
Thanks guys
Darren
 

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
73
Location
White Settlement Texas
Welcome to the forum Darren....

Yeah.....simple! Drive downhill! !!.:lolgoku:

Post up more information on your kart: weight of kart and driver and rear tire diameter .

Regearing doesn't automatically mean fried clutches...

Obviously, modding the engine is a way to increase top speed as well....beginning with governor removal....
 

Dazv

New member
Messages
31
Reaction score
0
Location
England
Haha where I can drive there isn't any hills! Umm not sure the weight of the kart I'm guessing 100lbs? I weigh around 180, I've heard removing the governor but don't want to blow my motor? Thanks for the reply
 

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
73
Location
White Settlement Texas
Just a smat of common sense and you'll be just fine....

Removing the gov'nor on small engines only slightly increases the chance of a ruddy mess....You'll gain a tad of top end, and especially with a Honda, keep the stock springs and they'll act as a govenor....

BTW: Me apologies if my English isn't quite up to snuff....but I thought I asked a question proper when I asked for the wheel diameter.....( Really, Darren, we need that...to address the sprocket/ clutch question....)
 

abelmanuel94

New member
Messages
7
Reaction score
0
Govenor is the way to go and it wont blow if its a gx160 honda i had one that i got of my dads compressor that had been runing for years and i take the govenor off and would run all day and ntn ever happen i just made sure it had good clean oil and thats it
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Welcome to the forum Darren....

Keep up Doug, he's been here for over two years :lolgoku:

We've seen a few threads regarding this kart & engine but WE'VE NEVER SEEN A SINGLE PIC!

:useless:

Please post some pics of your kart, that will give us a better idea of what you can do...

What is the current top speed?
 

Dazv

New member
Messages
31
Reaction score
0
Location
England
Hi guys thanks for the replies! Umm I have no idea of the size of the fly wheel when I stripped to engine down I remember it being around 10 inches? The rear wheel size is 11 inch I believe and in regards to photos I think I'd end up throwing my laptop against the wall and I'm not that great with that sort if thing. Umm the top speed at the moment is probably around 20mph at a guess.
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
Hi guys thanks for the replies! Umm I have no idea of the size of the fly wheel when I stripped to engine down I remember it being around 10 inches? The rear wheel size is 11 inch I believe and in regards to photos I think I'd end up throwing my laptop against the wall and I'm not that great with that sort if thing. Umm the top speed at the moment is probably around 20mph at a guess.

We are going to need some pics. It is really not that hard
 
Status
Not open for further replies.
Top