extending shift linkage

Status
Not open for further replies.

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
im trying to put a dirt bike engine in a mini chopper and the shift linkage is way behind my foot. im thinking either a suicide shifter or just extending it. which would be easier? and better for a beginner? how would i go about extending it to reach my foot?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Step into the motorcycle world, and look up "forward controls". Basically you'd mount a new shift lever in the right location and run a simple linkage.

I don't think you want to run a jockey shift/suicide clutch on this. You're already going to have your hands full (so to speak) with all that power. The typical jockey shift setup requires that you shift with your left hand, and clutch with your left foot. Obviously, you have to take your hand off the handlebar to shift. Less obvious to the inexperienced, is that you cannot put your left foot on the ground while idling in gear, and if you need to have your right foot on the brake, then you can put NO feet on the ground! This is where the whole "suicide clutch" term comes from. With experience you can manage it, but when you're new- well- make sure you're padded...

You could make the jockey shift a little less hazardous by mounting a clutch lever right on the shift handle, freeing up your left foot completely.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
I think simply extending it is your best bet. This is how that is done on my Yamaha XZ550. Pretty much just a very short tie rod.

 

Attachments

  • shifter.jpg
    shifter.jpg
    60.6 KB · Views: 10

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
haha nice. with the suicide could always throw it in nuetral to have foot off clutch. im just using a little 125cc lifan so its not that much power
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
True. It's more of a problem in real-world traffic. Although, you might be surprised about how much power that little engine can make, especially in a small, lightweight frame.
 

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
yea. i read it produces 9hp. such a small package but yet so powerful. im trying to find a forward control but cant really find a rather cheap one. so im thinking i might be able to fab my own. but i kinda doubt it cuz i got no skill at all with metal working
 
Last edited:

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
would it be cheaper to say find a part like you guys are suggesting or getting a machine shop to make a longer shifter?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Getting a machine shop to LOOK at your stuff will cost more.

Keep in mind that simply making a LONG shift lever will greatly increase the required travel to shift. It may even be more than your ankle will allow. Think leverage.

EDIT- I just looked over R97's second pic and realized Yamaha used the same mechanism to move the controls BACK on his bike. Same mechanism, different orientation. Still useable.
 

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
Ok sweet. I found one like that on ebay for about 30$ with free shiping when I get the money I will get it. But first I need to get the cdi ignition coil and wire harness for the engine
 
Status
Not open for further replies.
Top