Engine?

[usman111]

Dude There All Sold out Lol So If u sent him 140pounds/Dollars Ure Gettin A Rip!

umm what? They are 3 pounds and not sold out.

 

[MacfarlaneRacers]

16 and U Cant Afford An £140 Pit Bike Engine? :S I Can Afford A New Engine And Im 11 ?
Im Primary 7 !
Lol!

 

[MacfarlaneRacers]

4 available/4 sold :L 3pound ? Im Talkin About The Engine

 

[usman111]

16 and U Cant Afford An £140 Pit Bike Engine? :S I Can Afford A New Engine And Im 11 ?
Im Primary 7 !
Lol!

What the hell are you talking about? Im talking about the king pins and i never said i could not afford the engine i was asking if it was suitable you fool.

 

[KieranM]

usman111- do you have a calipers to measure the diameter of the pin

And MacfarlaneRacers, what the hell??

 

[usman111]

I dont have any calipers but i used a wrench and then measured the jaws of it and got 10mm, but their is about 2mm gap when i put the bearing on and just wondering if its suppose to be like this?

 

[redsox985]

Macfarlane, you really need to learn to type properly and not be so antagonistic.

 

[KieranM]

I dont have any calipers but i used a wrench and then measured the jaws of it and got 10mm, but their is about 2mm gap when i put the bearing on and just wondering if its suppose to be like this?

sometimes they turn down the part to be threaded a small bit, not 2mm though...unless its down to 8mm (1.25) thread.

And sorry I ment to say vernier callipers.

http://www.goearthtrek.com/Gravestones/Gravestones%20Images/vernier_calipers.jpg

 

[usman111]

So is there suppose to be this much play then? I can wiggle about the bearing a fair bit left to right on the actual shaft, but on the threaded part the bearing fits fine - i thought bearings were suppose to fit snugly?

 

[KieranM]

yes they are suppose to be a perfect snug fit..What bearings are you using?

 

[usman111]

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=270617462016&ssPageName=STRK:MEWNX:IT

 

[usman111]

Ok so i got some calipers and measured the pin shaft at 9mm and the full daimeter of the bearing at 26mm - the side diameters ( 7.5mm x 2 = 15mm ) = 11mm, so yeah looks like there is a 2mm gap.

edit---------

For the frame will 40mm x 40mm x 2.5mm Mild Steel be ok?

 

[KieranM]

Could you put up the code on the bearing?

2.5 is a bit thin, what welder are you using?

 

[usman111]

The code is on the link i posted - code 6000zz, on the actual bearings it reads - 6000z. And i will be using the Sealey MIGHTYMIG100.

 

[usman111]

Just wondering wether anyone has bought this steering package and knows if the parts are decent quality?

http://cgi.ebay.com/ebaymotors/ws/e...0312504881&viewitem=&sspagename=STRK:MEWAX:IT

 

[redsox985]

IIRC, they are Azusa parts and are good quality.