Engine Problems

Status
Not open for further replies.

lycsailor17

New member
Messages
27
Reaction score
1
I have a 5.5 hp craftsman motor, that wont start, I have cleaned out the carburetor many times but it doesn't work. It was working but there was gas pouring out of the carb. so I took it apart to reset the needle in the bowl, and now it wont start. The bowl fills up but The gas doesn't seem to be going into the cylinder. The motor will run if I spray carb cleaner in it, but then it dies. I cleaned out the bottom bolt that holds the bowl in place, but it still doesnt work. Whats wrong?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Remove the spark plug and clean. Reinstall it. Then, with full choke, pull several times. Remove spark plug and inspect. If plug is wet, you're fueling and likely have an ignition problem. If plug/cylinder are dry, you definitely have a fueling issue. It's very easy to miss a fuel passage when cleaning a carb, especially for the inexperienced. Report your results.
 

lycsailor17

New member
Messages
27
Reaction score
1
I didn't try it yet but what would be wrong and how could I fix it, if it was a fueling problem?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Aside from recleaning the carb (again, some passages are easily missed) make sure fuel is actually flowing from the tank to the carb. Make sure carb baseline settings are correct, too.
 

lycsailor17

New member
Messages
27
Reaction score
1
toystory_4wd I did what you said, I cleaned and checked the spark plug and its dry so its a carb issue. What should I do now?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
How to check for fuel flow to carb- Put some gas in the tank. Put a container under the float bowl, and remove the bowl nut. Fuel should be peeing into your container at a pretty good rate.
 

lycsailor17

New member
Messages
27
Reaction score
1
I know its getting to the carb because the bowl fills up, but doesnt get to the engine. Could you send me a link to a good guide to clean a Tecumesh carb?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
If the bowl is filling but no fuel is being delivered (at all), pull out the bowl nut/main jet again. Look for tiny passages and poke through with wire. Do you have a simple nut/bolt holding the bowl on, or is it actually a needle when you unscrew it?

Up inside the carb body directly above that bowl nut/bolt/needle is the main fuel passage into the venturi (main jet) be sure that is clear.
 

lycsailor17

New member
Messages
27
Reaction score
1
I cleaned out the holes in the bolt that holds on the bowl, I will try and clean the venturi and the idle jet tonight
 

lycsailor17

New member
Messages
27
Reaction score
1
It Works!!! toystory_4wd I did what you said and cleaned out the venturi and the idle jet and it fixed it. There was some junk really packed in there, I could hardly push the wire through it.
 
Status
Not open for further replies.
Top