engine performance help

[bob58o]

Well you wanted it milled anyway right?

 

[tgus3]

ok guys I know its been a long time but I finally have most of my parts a nd been working on putting it together.

So a couple(dum)questions.
1.the carb.could you explain how to hook up a throttle?

2.i spose I need the same plate from the old head for the rods to go thru?

3.I should of got a 20 thou rod instead of a 40 cause my pistons even with the top

4.Also, when I check the geom using thos caps do I leave em on or take em off when im done(dum ik)

That's all I can think of for now

 

[bob58o]

1. Do you have a throttle cable already? The cable and sheathing both need to be the correct length. The carb end of the cable needs an end that looks like the photo.

https://youtu.be/zDrERB9cb2c

2. I don’t think champion rockers need a push rod guide plate.
3. That’s ok, just use a 0.027” head gasket.
4. I’m pretty sure you can use lash caps with those valves, but you may want to call any parts site that sells them and ask.
248-767-0421 Russel @ NR. He is usually easier to get through email. Or call Jody at ARC tech support and ask. He is always super helpful. I usually ask my questions to ARC through FB messenger and get responses in no time at all.