engine is not running

Status
Not open for further replies.

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
i'm getting a bit annoyed now, this engine won't start, got spark, put my thumb on plug hole pressed down and pulled the recoil and it blew my thumb right off, so i got compression. i have spayed carb cleaner in there but it just gets blown right out the exhaust, has not even fired once, so i wan't to figure out whats up with that then ill think about the carb (which has bean cleaned), new fuel, new fuel lines new fuel filter, exhaust doesn't have too much carbon (pull recoil and a puff of air comes out), no sing of leaky gaskets, and the cylinder is nice and tight (so is the crank case), spark plug is snug, and from what i can see timing is good. whats going on!?
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
Spark in open atmosphere does not mean it is jumping the gap in real time conditions.
Check that proper plug and flywheel/magneto gap is correct. Use feeler gauges.
Double check that flywheel key has not sheared.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
i have tried the starter fluid trick already, i don't get anything.
i have the proper plug, cjy8 just like mfg says.
i'll once again check the fly wheel, i almost hope thats what it is.
thanks for the help
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
had to say that didn't i. fly wheel key is sheared (thanks russ, it prob would have taken me a while to find that because the fly wheel is also tapered so it is still sorta held on) only problem is that the key was built into the flywheel, ebay here i come!:mad2:
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
lets just hope thats the only problem! a fly wheel is only like 4.50 so it shouldn't be too big a problem, just me going crazy waiting for it to come. i suppose i can call this a learning experience, so in one way its a good thing
 
Status
Not open for further replies.
Top