Engine Help

Status
Not open for further replies.

oldbikerarlo

Old guy
Messages
449
Reaction score
2
Location
Marana, Az.
Did you take the idle jet out, and check the passages? then put the jet back in with the air holes in line with the air passage in the carb body? replace your gaskets too.
 

oldbikerarlo

Old guy
Messages
449
Reaction score
2
Location
Marana, Az.
The jet pieace should be tube like plastic with a hole through the sides and a hole in the bottom, the bottom hole is the jet the holes through are for the air passage that acts as the venturi. then they exit into the carb main venturi right at the throttle plate through 4 small holes one should have an adjusting needle but its behind a plug so don't mess with it.
 

CaptCanadia

New member
Messages
792
Reaction score
1
Location
Acton, CA USA
Well I turned the idle screw up a tiny bit and now it runs. I guess the idle was too low. Now my clutch engages a little bit so I'm worried if it's on any slant at all it will roll away.
 
Status
Not open for further replies.
Top