Engine for Yerf Dog 3203

Status
Not open for further replies.

kc9ljo

New member
Messages
22
Reaction score
0
I have a yerf dog 3203 that I bought with no engine. I have the jack shaft and clutches ect all i need is an engine. Can someone tell me what engine options I have that will bolt right in? And the best place to purchase. I would not mind going with a little more power than stock, as long as it is still a direct bolt in.
Thanks
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
If your interested in used engines, look on craigslist for Honda, Techumseh, and Briggs and Statton engines, 5-8hp.

If you want a new engine, I would suggest either a Honda, or a Robin Subaru. Subaru has newer technology than Honda and is less expensive, but Honda has more performance parts available.

http://engines.honda.com/models/series/gx

http://robinamerica.com/series.aspx?sid=7

http://www.ebay.com/itm/Robin-Subaru-6HP-SP-170-EX17-Engine-/200691552654?pt=LH_DefaultDomain_0&hash=item2eba26118e#ht_1263wt_905

http://www.ebay.com/itm/Robin-Subaru-Engine-9-HP-Free-Shipping-/290645697399?pt=LH_DefaultDomain_0&hash=item43abd56377#ht_637wt_1037

http://www.ebay.com/itm/Robin-Subaru-7-HP-EX21-Engine-/260918354192?pt=LH_DefaultDomain_0&hash=item3cbff22110#ht_500wt_1156

http://www.northerntool.com/shop/tools/category_engines+honda-horizontal

Not all of the 7-8hp engines will fit, but most 5-6 should. Make sure whatever you get has a keyed shaft (with a diameter to match the bore of your clutch). I would not suggest you buy a more than 8hp engine if you have a 20 or 30 series clutch.
 

supermanotorious

Winchmaster 5000
Messages
2,088
Reaction score
103
Location
New River, AZ
A clone engine from Harbor Freight will bolt right on, that's exactly what I put in my 3203, usually you can find a coupon for $99 or $109, then for more power, get THIS and you'll be around 7.5 - 9 HP, you will save hundreds over the name brand engines and as long as you maintain the clone it will perform for you
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
usually tecumseh engines will have the same mounts up to 10hp. (im putting a 10hp in a mini bike) but briggs, that ive seen, have a larger mount 8hp and up.

a 6.5 clone will fit the bolt pattern of the old tecumseh, a 13hp clone will not. it would really help if they stuck with one mount up to a larger HP rating
 

kc9ljo

New member
Messages
22
Reaction score
0
Regarding the HF clone engine, it looks like the rewind would need to be turned either 90 or 180 so it pullls out the back. Is that correct? Also does it require any modification to get the throttle hooked up?
Thanks
 

supermanotorious

Winchmaster 5000
Messages
2,088
Reaction score
103
Location
New River, AZ
It depends on how you mount the engine whether you need to turn the pull cord but there are 3 8mm bolts involved so its very easy to rotate and you get 6 positions to choose from, throttle linkage is easy as shown here:
 
Status
Not open for further replies.
Top